BestofBest12

Tony (Hooked on Mods) wonderful 1332 with homemade stock

Specs: OAL: 34" Barrel: 20" Weight: not yet weighed, but feels about 6 lbs w/scope Scope: 6x BugBuster with medium height rings Brake: Solid aluminum, my design to protect crown. Mods: Ported valve, tubing breech seal, flat-top, stock volume valve and o-ring nylon piston, light valve spring, longer hammer spring with spring guide, polished hammer and trigger with lighter spring. RJ short breech, drilled Welker band to support pump pin. Will add trigger shoe once I make a shim.

HOLY COW!! Look at Rich's new creation


Hi Joel Here are some pics of my rifle- RJ machine long breech-extended bolt and bolt handle and trigger-hammer work- black trigger shoe are all by Roy Weid (MA) the valve is a combination between a boss valve and one from Roy (I took the front half of the boss and drilled out the angled exhaust port and used the rear half and internals of Roy's valve) BSA 6-24x44 mil-dot scope with 8"sniper sunshade with BSA laser and flashlight attached to it-grips by Rick-- brass end cap by Art--bipod by Rock-Mount (works great as my forearm stock)--modified 14"barrel by ME--custom shoulder stock by ME--custom barrel shroud by ME -- this is about as far as want to go with co2 I didn't bulk fill wanted to keep the weight down as much as I could -weight is 5.6 lbs this gun hits very hard and very accurate at 40-50 yards I think its about time to move up to HPA on my next gun---RICH

Classicalgas AKA Scot's non Crosman Mods

Bulk co2,about 12 ft/lbs, started out as a ruined pump rifle, a Benjamin 342

Chinese AK trainer, all out tune with chopped barrel, refinish, etc...

This gun I built for my 6 year old, bulk co2.20cal,was a hold down silverstreak with a ruined pump tube

And one Crosman 150

150 with a 1400 barrel,refinished

Chuck's great looking 2240

I finally got it done today the last piece came from Roy, with extended bolt, and barrel shroud, boss valve and bulk fill, polished trigger, and custom spring and guide, I have done every modd. I could think of haven't chronyed yet. But it is putting holes in 1/2 plywood...idea for the stock came from Larry

Greg Schutte's inovative 1377 Pellet Holder

I got tired of carrying around a tin of pellets so I made a Gun Mounted Ammo Container. I call it the GMAC. I'm working on a version for my 2240. It works really Sweet!

George Ewen's 2240 SS (Short and Sturdy)

I just put the grip frame in the milling machine and cut a notch into it. It could be done with a file if you have the time and energy. As for the shorter barrel I can see no difference in accuracy,,,,,,,,,,,,,but I think that it is louder. and the way it looks and feels

Timothy Miller's .32 caliber 22xx carbine

I finally found a good way to hang the 22ci Wevo HPA tank from the .32 caliber 22xx I built. I am using macroline quick disconnect fittings and 12 inches of macroline. The gun uses HPA at 1125 psi, coming through a modified Nitro Duck I-reg regulator. Here’s what the gun looks like now:

John Ulrich's Sharp looking 2300's

Oops...changed his mind on the scope

Sweet looking bulked 2300. Looks like Rick's grips and some of Max's work.